![]() PDF along with other things points to the fact that Spectra PhotoSync being the better tint to 3M Crystalline, which I have had on 2 of my personal. I had reservations about this from the get go but I went with it mainly based on my research and not hearing people bad mouth the tint. Thus, crystalline and amorphous, both are solids that may exhibit similarities in terms of their appearances, but are actually vastly different from each other in terms of their elemental makeup and properties. I decided, against my better judgement, to go with PhotoSync. ☞ 6) CuttingĪ crystalline solid, when cut using the right cutting tool, cleanly splits into two parts.Īn amorphous solid, on the other hand, give irregular cuts, because of its uneven composition. Had Photosync installed September 2016 and no complaints yet, very happy with it. Was a tough choice between those two, and likely would be happy with either. That's about 300 - 350 more than 3M Crystalline in this area. That is why crystalline solids are known as anisotropic. Cost me 900 for all three sides plus front wind shield. For example, light traveling through a crystal travels at different speeds in different directions within it. 3M is not ceramic based where as Xpel is. With self-healing technology, best stain resistance in the auto industry, and a near crystalline finish, XPEL Paint Protection Film is guaranteed to protect your vehicle’s paint job. ![]() Its lightest shade blocks a high-level of infrared light and 34 percent of heat. Both BTU and Spectrum Analyzer comparison with Photosync 45 (lighter by 15) and Stratos 30.Update In 2019, Prestige Film Technologies (One post I read says 3m has a more brown hue where the Xpel is a grey/blue-ish grey hue. Hence, they are known as isotropic materials.Ĭrystalline solids, on the other hand, have these characteristics in varying amounts in different directions. A multi-layer optical film 3M Crystalline combines 200 layers in its film, but is thinner than a Post-It Note, which offers a higher heat rejection than darker film. Just like in liquids, in amorphous solids, properties such as electrical conductivity, thermal conductivity, mechanical strength, refractive index, etc., remain the same in all directions. ☞ Isotropy and AnisotropyĪmorphous solids display several of the characteristics of a liquid. This happens because, in the crystallization process, energy is released, which goes on to compensate for the heat loss. These break points indicate the beginning and end of the crystallization process, during which, the temperature remains constant. The technology behind the engineering of Spectra. The graphical representation of the cooling characteristics of an amorphous solid gives a smooth curve, while that of a crystalline solid has two break points along the curve. Spectra Photosync IRD is the second Generation iteration of the Spectra Photosync, which was for years the best window film in the industry. Spectra PhotoSync IRD currently has the highest recorded heat-rejection in the market, up to a TSER of 81.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |